RPM960-H14
Photo Link Module
Rev.C
5/5
Notes
1) LEDV
CC
(1pin), V
CC
(6pin) and VIO (7pin)
"
Other power source can be used difference between LEDV
CC
and VCC and VIO. (VIO < VCC+0.3V)
2) Caution in designing board lay-out
To get maximum potential from RPM960-H14, please keep in mind following instruction.
"
The line of RXD (4pin) should be connected at backside via through hole close to RPM960-H14 pin lead. Better not
to be close to photo diode side (8pin side).
襎his is to minimize feedback supplied to photo diode from RXD.
"
Better to be placed at more than 1.0cm radius from photo diode (8pin side) and also away from the parts which
generate noise, such as DC / DC converter.
"
As for C1 between 6 and 8 pins, it should be placed close to RPM960-H14.
3) Notes
"
Please be sure to set up the TXD (3pin) input to be L (under 0.6V) except transmitting data.
(For < 90?sec. ON duty < 25%).
"
Powerdown current might increase if exposed by strong light (ex. direct sunlight) at powerdown mode.
"
Please use by the signal format which is specified by IrDA Ver1.3 (Low Power) except 4 Mbps.
There might be on error if used by different signal format.
4) Eye safe
"
EN60825-1 (IEC60825-1 amendment2), Class1 Eye safe.
External dimensions (Unit : mm)
2.COPLANARITY : 0.1mmMAX
1.TOLERANCE : ?.2mm
A
UNIT : mm
NOTE
ETH396
PinPD
LED
8
1
2.2
R1.0
R1.1
0.95
P0.95?=6.65
2.59
0.37?.1
4.0
1.4
1.1
2.2
0.78
0.15?.1
0.76
8.0
2.8
0.48
0.6
A Part Size (Shield Case underside size)